Grouw 93505 Manuel D'instructions page 27

Read the manual before use.
For outdoor use only.
The weed burner and gas
bottle should be stored out of
the reach of children in a dry,
dust-free and well-ventilated
location.
The burner and the area
around it will get very hot
during use. Avoid touching
these parts and allow them to
cool fully before transporting
or storing the weed burner.
USE
IGNITION
Weed burner with piezo ignition
Turn the control valve (5) anticlockwise one
revolution (� g. 2). Immediately press the
button (11) until the gas from the burner
ignites (� g. 3).
Weed burner with normal ignition
Turn the control valve (5) anticlockwise one
revolution. Immediately ignite the gas from
the burner using a match or a lighter.
SAFETY MEASURES
Hold the nozzle downwards the whole time
(max. 45°) and at a distance from animals and
people.
ADJUSTMENT
Adjust the � ame by turning the control valve
(5).
BURNING WEEDS
The GROUW weed burner is an
environmentally friendly and non-toxic
method for removing unsightly weeds from
all patios, driveways, footpaths, etc.
This product is not intended for use on lawns
and � ower beds.
When the � ame is used on weeds that need
to be removed, the leaves are dehydrated, so
the weeds dry out.
The weeds must not be burned, but only
heated up with the tip of the � ame. Therefore
maintain a reasonable distance from the
plant. For particularly resistant or tree-like
weeds (wild vegetation, plants with taproots,
etc.), it may be necessary to heat the weed
for longer. Repeat treatment may also be
necessary after a few days.
SAFETY MEASURES
The weed burner must be used outdoors at a
safe distance from any � ammable material.
Always hold the nozzle facing downwards
to avoid � ame-up. If this happens, hold the
weed burner still in a vertical position for a
few seconds.
Warning! There may be a danger of � re
in very dry conditions. Never leave the
weed burner unattended when it is on. It is
dangerous to use damaged appliances. In
the event of irregularities in the supply of
gas, check the content of the gas bottle (see
"Checking the content of the gas bottle").
If there is still gas in the gas bottle, the
problem may be remedied by cleaning the
nozzle (see "Cleaning the nozzle").
SWITCHING OFF
Turn the control valve (5) clockwise until the
valve is completely closed.
GB
27