Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
3.
Carefully remove the flash tube from its socket by grasping the connector and lifting
upwards using a slight rocking motion.
4.
See replacement parts table (Section IIB) for a complete list of Federal Signal lamps that
are available. Install a new flash tube by fully seating it into the socket.
5.
Reassemble the unit.
6.
Test light for proper operation.
B. Replacement Parts.
Description
Plastic Dome Assembly, Amber
Plastic Dome Assembly, Blue
Plastic Dome Assembly, Clear
Plastic Dome Assembly, Gree
Plastic Dome Assembly, Red
Fresnel lens, Clear
Dome ring gasket
Surface mount gasket
Strobe Tube
Printed circuit board assy., 12-24VDC
Printed circuit board assy., 120VAC
Printed circuit board assy., 240VAC
C. Accessories.
Description Part No.
Mounting Bracket, Surface 371BRCKT
Conduit hub kit, 3/4" N.P.T. 8459138
Close-up plug, 1" N.P.T. 8459130A
III. SERVICE
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by a
Return Material Authorization. This R.M.A. can be obtained from a local Distributor or
Manufacturer's Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction, should
be provided.
Address all communications and shipments to:
Industrial Systems
2645 Federal Signal Drive • University Park, IL 60484-3167
Tel.: 1-708-534-4756 • 1-877-289-3246 • Fax: 1-708-534-4852
www.federalsignal-indust.com • www.fs-isys.com
Part No.
K8459125
K8459125-01
K8459125-02
K8459125-03
K8459125-04
K8422B428
K8459123
K8459127
K8107178
K2001265-01
K200865-02
K200865-03
4
Publicité
