Safety Notices; Accessories List; Extent Of Delivery; Warning Notices - Weller WTCP 51 Manuel D'utilisation

5. Safety Notices

The manufacturer assumes no liability for uses other than those specified in the
Operation Manual as well as any self-made changes to the unit.
This Operation Manual and the warning notices therein should be read carefully as
well as kept in good view and near the soldering unit. Failure to observe these warning
notices can lead to accidents, injuries or damage to health.
The WELLER Soldering Station WTCP 51 complies with the EU Declaration of
Conformity according to the fundamental safety standards of the directive
89/336/EWG and 73/23/EWG.

6. Accessories List

53215299 FE50M Magnastat soldering iron with device for
solder fume extraction
53209999 Extension cord 4m
54173499 DIL-16-WG desoldering tip dual in line 16
54173899 DIL-24-WG desoldering tip dual in line 24 RM 7.62
54173999 DIL-24 desoldering tip dual in line 24 RM 15.24
54174599 DS-TO desoldering tip for round ICs TO-5
54173299 FP-7 Flat Pack soldering tip 9mm wide
51304099 Desoldering set DS-7
51302099 Tin-a-Print for tinning strip conductors

7. Extent of Delivery

Power unit P 51 / Soldering iron TCP S / Safety support rack KH 20 / Operation
Manual
Picture: Soldering tip choices, see page 39 + 40
Picture: Circuit diagram, see page 42
Picture: Exploded view, see page 44

8. WARNING NOTICES!

1. The power cord may be inserted in approved power sockets or adapters only.
2. Keep your work area in proper order.
Always return the soldering tool to its original holder when not in use. Do not bring
combustible materials near the hot soldering tools.
3. Take care for the surroundings.
Don't use the soldering tool in a moist or wet environment.
4. Protect yourself against electrical shocks.
Avoid touching grounded parts with your body, e.g. pipes, heating radiators, stoves,
refrigerators.
5. Keep children at a distance.
Don't allow other persons to touch or disturb the soldering tool or cord. Keep other
persons away from your work area.
6. Store your soldering tool in an appropriate place.
Unused soldering tools should be stored in a dry location which is out of the reach of
children (some place high or in a locked cabinet). Switch off all unused soldering
tools.
7. Do not overload your soldering tool.
Use the soldering tool only with the specified voltage or specified pressure and
pressure range.
8. Use the appropriate soldering tool.
Don't use a soldering tool whose performance is not adequate for your work. Never
use the soldering tool for purposes for which is was not designed.
9. Wear suitable work cloths.
There is a danger of burning yourself with liquid solder. Wear the corresponding
protective clothing in order to protect yourself against burns.
16