ARIETE Diablo 1600 Mode D'emploi page 12

GB
Replacing the dust bag
When the indicator light shows red, then it is time to change the dust bag.
- lift the bag compartment by pushing the relevant lever inwards (FIG. 9)
- remove the container (FIG. 10).
- take out the bag, being careful not to tear it: slide the stiff card section out along the guides and then
throw the bag away
- insert a new bag by sliding the stiff card section in along the guides and then place the container in its
seat
- close the dust compartment lid.
Cleaning/replacing the pre-motor filter
The pre-motor filter needs cleaning on a regular basis and it should be replaced every 6 to 9 months,
depending on use.
- Remove the bag (FIG.10).
- Slide the filter out from the compartment (FIG. 11).
- Remove the filter, and then shake it vigorously to clean it. If the filter is extremely soiled, wash it with
lukewarm soapy water, rinse it well and leave it to dry. NEVER use artificial means to dry the filter. To
replace the filter, contact an Assistance Centre.
- Replace the filter in its compartment and refit it. When you refit the compartment, make sure that the
rough surface of the filter is visible.
- Lastly, refit the dust bag and make sure that the filter compartment is correctly in place before using the
cleaner.
Cleaning/replacing the exhaust air filter
The exhaust air filter needs cleaning on a regular basis and it should be replaced every 6 to 9 months,
depending on use.
- Remove the exhaust air filter cover (FIG. 12).
- Lift the filter out from its compartment (FIG. 13) and shake it vigorously to clean it. If the filter is extre-
mely soiled, wash it with lukewarm soapy water and leave it to dry. NEVER use artificial means to dry
the filter. To replace the filter, contact an Assistance Centre.
- Replace the filter in its compartment and refit it. When you refit the compartment, make sure that the
rough surface of the filter is visible.
Make sure that the filter compartment is correctly in place before using the cleaner.
TROUBLESHOOTING
Thermal cutout switch
The vacuum cleaner is equipped with a thermal cutout switch to protect it in the event that the motor over-
heats. If the vacuum cleaner suddenly switches off by itself, proceed as follows:
- Switch off the vacuum cleaner and unplug it from the mains power.
- Look for the origin of the overheating (blocked suction pipe, dirty filter, etc.)
- Clean the pipe, empty the dust bag, and clean the filter, if necessary.
- Wait for about 30-40 minutes to allow the motor to cool down.
All manuals and user guides at all-guides.com
10