Valor StoneFire SFFT01 Instructions D'installation

The kit is used on the 530 engine fi tted with the SFFK01 Stonefi re Freestyle Framing Kit.
Note: The SFFK01 Framing Kit MUST protrude from the wall fi nish by at least 1/2 inch to install the 4-sided trim.
SFFT01 4-Sided Trim
Overview
(Heater, Fronts, Frets and Door Kits sold separately)
Note: The protruding extension baffl e assembled to the top pannel of the
SFFK01 must be removed (if not already removed) in order to install this 4-sided trim.
Remove the extension baffl e by inserting a Philips screwdriver between the top pannel
and the baffl e itself as shown and remove the 2 screws. Then simply pull the baffl e out
of the gap and discard.
THE TOP CONVECTION BAFFLE MUST TOUCH THE FREESTYLE FRAME WHEN
INSTALLED.
Installation
Once the wall around the fi replace is fi nished,
1. Release the four screws on each side of the
trim—two per side.
2. Slide the 4-sided trim onto the protruding
framing ensuring that the convection baffl e
at the back of the frame is on top. THE
BAFFLE MUST TOUCH THE FREESTYLE
FRAME WHEN INSTALLED.
3. Center the trim on the fi replace and tighten
the four screws of the trim against the sheet
metal framing to maintain in position.
4001764-02
© 2009, Miles Industries Ltd. All rights reserved.
All manuals and user guides at all-guides.com
SFFT01
FREESTYLE 4-SIDED TRIM FREESTYLE 4-SIDED TRIM
INSTALLATION INSTRUCTIONS
For use only with
Valor Model 530 Heater fi tted with the SFFK01
27-3/8" (69.4 cm)
1" (25.8 cm)
2-1/2"
(6.4 cm)
Convection
Baffl e
screws
Rear View
REAR
CONVECTION
BAFFLE ON TOP
AND TOUCHING
THE FREESTYLE
FRAME
TM
Remove extension baffl e
Protruding SFFK01
Framing Kit min. 1/2"
from wall finish