Trix 18.3 /Bad IVh Serie Mode D'emploi page 10

Safety Notes
• This locomotive is only to be used with the operating system
it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This locomotive must never be supplied with power from
more than one power pack.
• Please make note of the safety notes in the instructions for
your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
Important Notes
• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• http://www.maerklin.com/en/imprint.html
10
All manuals and user guides at all-guides.com
Functions
• Built-in electronic circuit for operation with a conventional
• Automatic system recognition between digital and analog
• The full range of functions is only available under Trix Sys-
• Built-in headlights that change over with the direction of
• Minimum radius for operation is 360 mm/14-3/16".
• A smoke generator can be retrofitted to the locomotive - also
Notes on digital operation
• The operating instructions for your central unit will give you
• The values set at the factory were selected to guarantee the
• The setting done at the factory does not permit operation with
DC power pack, Trix Systems or NMRA DCC digital systems.
operation.
tems and under DCC.
travel. They can be turned on and off in digital operation.
for analog operation.
exact procedures for setting the different parameters.
best possible running characteristics.
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC
power operation (CV 29/Bit 2 = 0).