Lux Tools E-AS 710/20 Notice Originale page 49

All manuals and user guides at all-guides.com
Astsaege_Elektro_468283.book Seite 49 Montag, 24. Oktober 2016 9:44 09
NOTICE! Environmental damage!
Since the saw chain oil can penetrate
the environment during operation,
biologically-degradable special veg-
etable-based saw chain oils should
be used.
– Lay device securely with the tank
cover (9) upwards.
– Before opening, clean the tank cover and
the filler neck if necessary.
– Slowly open and remove the tank cover.
– Carefully fill up the saw chain oil. Do not
spill!
– Tighten the tank cover by hand.
– If you have spilled any saw chain oil, be
sure to wipe it up.
Adjusting working position of the drive
unit
► P. 5, item 12
– Press unlock button (22) and bend drive
unit (8) until it clicks into place.
Operation
Check before starting!
DANGER! Risk of injury! The
device must only be put into opera-
tion if no faults are found. If any part
of the device is defective, it must be
replaced before the next use.
Check the safety equipment and the safe
condition of the device.
– Check all parts for their firm fit.
– Check whether there is any leakage.
– Check whether there are visible defects:
broken parts, cracks, etc.
– Check the device for correct chain ten-
sioning.
Attaching the extension cable
► P. 5, item 11
Note: Lay the connection cables in
such a way that they cannot be
caught by branches or similar items
when cutting.
– Insert device plug in the extension cable
coupling.
– Pull the extension cable through the
cable grip (23) as illustrated.
Starting the device
► P. 5, item 10
– Firmly hold product with hands and use
carrier belt.
– Press the switch-on safety lock (5).
– Press the start button (6).
The device starts up.
Use
Before use, familiarize yourself sufficiently
with the sawing technique for chain saws.
You will find information about this in the
trade literature. We recommend that you
attend suitable training sessions. The notes
here serve only as a complement!
Correct posture
DANGER! Risk of injury! Never
work on unstable subsurfaces!
Never work above shoulder height!
Never work while standing on a lad-
der!
Do not work bent too far forward!
Only use the device under favourable
weather and site conditions!
– Stand with both legs securely on the
ground.
– Heed obstacles in the work area.
– While you are working, always hold the
device fast with both hands!
– The carrier belt is be carried on left shoul-
der!
Hold the device:
– with the left hand on the handle
– with the right hand on the handle.
– balanced in a secure position.
Here's how to saw correctly!
DANGER! Risk of injury! Always
switch the motor off before you put
the device down!
• Search the work area and remove objects
which are in your way.
• When you begin work, check the safety of
the device (► Check before starting! –
p. 49).
• Take the device in both hands as
instructed.
Risk of rebound!
Rebounds occur if the upper edge or tip of
the saw rail touch wood or other hard
objects. The device is thrown with high
energy back and forth, which can cause
extremely severe injuries.
GB
49