Lux Tools E-AS 710/20 Notice Originale page 46

All manuals and user guides at all-guides.com
Astsaege_Elektro_468283.book Seite 46 Montag, 24. Oktober 2016 9:44 09
GB
• Do not overreach and do not cut above
shoulder height. This helps prevent
unintended tip contact and enables bet-
ter control of the chain saw in unex-
pected situations.
• Only use replacement bars and chains
specified by the manufacturer. Incor-
rect replacement bars and chains may
cause chain breakage and/or kickback.
• Follow the manufacturer's sharpening
and maintenance instructions for the
saw chain. Decreasing the depth gauge
height can lead to increased kickback.
Safety information for pole-mounted
pruners
• Make sure that the working area is free
from obstacles. Do not allow the tip of the
sawing rail to come into contact with a
fence, branch or similar when operating
the product.
• Do not use the product on ladders or
unstable surfaces. Stand firmly on the
ground with both feet to prevent loss of
balance.
• To protect yourself against electric shock
you should never use the product closer
than 15 m from overhead power lines.
• To protect yourself against falling
branches you should not stand directly
underneath the parts to be cut. Do not
hold the product at an angle of more than
60° to the ground.
Additional safety information
• It is recommended that the user is
instructed by a qualified specialist with
regard to the operation of the chain saw
and the use of safety equipment based
on practical examples prior to first com-
missioning.
• This product is not intended to be used
by persons (including children) or who are
limited in their physical, sensory or men-
tal capacities or who lack experience
and/or knowledge of the product unless
they are supervised, or have been
instructed on how to use the product, by
a person responsible for their safety.
• Children should be supervised to ensure
that they do not use the product as a toy.
• Children and adolescents are not allowed
to operate the chain saw. The same
applies to persons who are not or not well
enough acquainted with the chain saw.
• The operating instructions should always
be within easy reach.
46
• Persons suffering from fatigue or who are
not physically fit must not operate the
chain saw.
• Keep the handles dry and free from
grease. Slippery handles can cause
accidents.
• Keep a firm hold of the electrical tool
with both hands while working and
make sure you are standing firmly.
The electrical tool is more safely guided
using two hands.
• Do not leave tools, objects or cable
laying around in the vicinity of the
device. If you stumble, you may injure
yourself on the power tool.
• Make sure that all safety facilities and
handles are mounted when using the
product.
• Never attempt to operate an incompletely
mounted product or a product with
impermissible modifications.
• Wait until the electrical tool has come to
a standstill before putting it down.
• Do not use any accessory that has not
been provided and recommended by
the manufacturer specially for this
electrical tool. Just because the acces-
sories can be fixed on your electrical tool,
no secured use is ensured.
• Remember that moving parts may also
be located behind ventilation and venting
slots.
• Symbols appearing on your product may
not be removed or covered. Information
on the product that are no longer legible
must be replaced immediately.
Observe the safety instructions be-
fore using the product for the first
time.
Risk of injury due to electrical power!
Read and observe the operating in-
structions before commissioning.
Wear sturdy shoes when working with
the device.
Wear protective gloves when working
with the device.
Wear hearing protection when work-
ing with the device.
Wear protective goggles when work-
ing with the device.