Lux Tools E-AS 710/20 Notice Originale page 48

All manuals and user guides at all-guides.com
Astsaege_Elektro_468283.book Seite 48 Montag, 24. Oktober 2016 9:44 09
GB
• Instructions for use
Assembly
DANGER! Risk of injury during
operation! Improperly mounted
parts can cause severe and even
fatal injuries when using the device!
This device may only be commis-
sioned if all parts are mounted com-
pletely and tightly and no part is
damaged!
• Therefore, read the whole chap-
ter before you assemble the
parts!
• Assemble the parts carefully and
completely.
• Use tools when their use is sug-
gested.
DANGER! Risk of injury during
assembly! Parts may only be
assembled and disassembled when
the motor is switched off (de-ener-
gise device).
WARNING! Risk of injuries due to
cuts! The teeth of the saw chain are
very sharp! Protective gloves must
be worn for all work on the chain.
DANGER! Risk of injury! An
improperly mounted saw chain
causes uncontrolled cutting behav-
iour of the device! When assembling
the chain, heed the prescribed run-
ning direction!
Attaching the saw bar
► P. 3, item 2
– Assembling saw bars (11) and (12) until
they are latched and tighten screw (19).
– Setting the length of the saw bar
Setting the length of the saw bar
► P. 3, item 2
– Loosen screw (20) and pull out saw
bar (12) of desired length.
– Tighten screw (20).
Assemble bar handle
► P. 3, item 3
– Insert grip section (21) on saw bar (12).
– Insert bar handle (3) on grip section (21)
and tighten screw.
48
Assembling the saw rail and saw chain
– Loosen the screw (17) on the chain wheel
guard (7) and remove chain wheel guard
(► P. 4, item 4).
– Fit guide rail (15) in such a way that the
bolts (13) grip in the guide rail (► P. 4,
item 5).
– Place Saw rail (1) on the guide rail (14)
with the guide groove (15) (► P. 4,
item 6).
Note: When attaching the chain,
heed the correct position of the guide
groove (saw rail).
– Place the saw chain (2) around the chain
wheel (16). Heed the assembly direction.
– Place the saw chain (2) around the saw
rail (1).
– Attach the chain wheel guard (7).
– Tighten the screw (17) by hand.
Tensioning the saw chain
► P. 5, item 8
– Tighten the tension ring (18) until the
chain lies on the underside of the saw rail
(► P. 5, item 9).
– Tighten the screw (17).
Letting the saw chain run in
During the run-in time, re-tension the saw
chain and rail after a maximum of 5 cuts.
Checking the tensioning of the saw chain
The saw chain is tensioned correctly if it lies
close against the underside of the saw rail
and can be moved easily by hand.
Readjust tension of the saw chain when nec-
essary (► Re-tensioning the saw chain –
p. 51).
Checking the chain greasing
The device may not be used without suffi-
cient chain greasing. Insufficient greasing
reduces the service life of the device.
– Check the oil quantity in the tank.
– Start the device.
– Hold the running saw chain approx.
15 cm over a suitable surface for a time .
If there is sufficient chain greasing, the oil
spraying off of the saw chain will form a slight
trail.
Filling up saw chain oil
► P. 5, item 8