Parkside PEH 950 Mode D'emploi Et Instructions De Securite page 11

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
IMPORTANT SAFETY ADVICE
To be read in conjunction with the advice in the accompanying booklet on safety before using for the
first time.
The PEH 950 power planer is intended to be used for planing wood (e.g. beams, boards).
If the mains cable is damaged or cut through during the work - never touch the cable - pull out the
mains plug immediately. Never use electrical equipment with damaged cables.
For operating the planer for longer periods and particularly if dust that may be hazardous to heath is
created, the planer should be connected to a suitable external vacuum device.
Wear a dust mask.
Make sure you only use sharp blades.
Always keep the power cable fed to the rear of the machine.
Never plane over metal objects, nails or screws.
Only place the planer against the workpiece after switching it on.
¾
The base plate
Do not clear dust etc. from the dust outlet
trapped planing debris.
OPERATION
Operating state
Switching On/Off:
No-load running:
WARNING:
Always remove the plug from the mains socket before working on the planer.
Take note of the mains voltage. The voltage must agree with that shown on the rating plate
(equipment shown as 230 V can also be used with 220 V).
ON / OFF SWITCH
On the grounds of safety the ON / OFF switch
operation. It must always be pressed during operation.
All manuals and user guides at all-guides.com
must always lay flat on the workpiece when working.
º
The PEH 950 power planer has INTELLIGENT POWER CONTROL.
This electronic management system monitors and controls your power planer
in its various operating states;
Feature
The IPC electronic system start-up mode ensures that the
motor starts up slowly and gently. This large ly avoids
heavy transient current surges, and means that electrical safety cut-out
devices are not generally tripped (building sites, domestic premises).
After switching on, the IPC electronic management system run-up mode
takes the planer speed up to the pre-set required value. After this is reached,
the IPC system speed control mode keeps the grinder operating at a
constant speed.
with your fingers. Use a piece of wood to dislodge any
» cannot be locked in the ON position for continuous
t k
11 11 11 11
w