Operation; Maintenance - pullman Ermator T 7500 Manuel D'utilisation

Part no Hubbell part no
E HBL7774WO
F HBL460B7W
G HBL460R7W
H CS8375
Before use
WARNING: Before using the dust extractor
make sure that the power and voltage
corresponds with the voltage shown on the
machines rating plate, including extension
cords.
WARNING: Connect to a properly grounded
outlet only. Refer to
on page 9
Grounding instructions
WARNING: The dust extractor must be
grounded. If it should malfunction or
breakdown, grounding provides a path of
least resistance for electric current to reduce
the risk of electric shock. The dust extractor
is equipped with a cord having an
Introduction
WARNING: Use personal safety equipment,
Personal protective equipment on
refer to
page 7 , during service. Dust can be exposed
during maintenance and service.
WARNING: Most accidents involving
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.
WARNING: The motor should be switched
off during operations described in this
chapter unless otherwise stated.
966 - 003 -
Standard
®
Twistlock
IEC 60309
IEC60309
®
Twistlock

Operation

Grounding instructions

Maintenance

Description
Well plate
INLET MALE, 60A, 3-PHASE, 480V, 4 Wire
RECEPTABLE FEMALE, 60A, 480V, 3-PHASE, 4 Wire.
INLET MALE, 50A, 3-PHASE, 250V, 4 Wire.
equipment-grounding conductor and
grounding plug. The plug must be inserted
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
To start and stop
Push the green button (A) to start the dust extractor.
Push the red button (B) to stop the dust extractor.
A
WARNING: All checks involving electric
components should only be performed by a
licensed electrician.
Maintenance schedule T-Line Dust
Extractor
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
B
9