Garmin KT15 Manuel De Demarrage Rapide page 4

All manuals and user guides at all-guides.com
1
Snap the charging clip
device .
2
Plug the small end of the power cable
into the mini-USB port on the charging
clip cable.
3
Plug the power cable into a power
source.
The status LED is solid red when the
collar is charging.
4
After the status LED turns solid green,
remove the charging clip from the
collar.
Acquiring Satellite Signals
Both the collar and handheld device must
acquire satellite signals before you put the
collar on your dog. Acquiring satellites can
take a few minutes.
1
Go outdoors to an open area.
2
Turn on both devices (page 2).
Quick Start Manual
3
onto the Select the power key on the handheld
device.
When the collar has acquired satellite
signals, the status LED flashes a double-
blink or triple-blink in green.
Adding a Dog to the Atemos
Handheld Using Wireless Pairing
1
If the dog collar device is on, turn off
the dog collar device.
2
Hold
emits two series of beeps (about 2
seconds), and then release .
The status LED flashes rapidly in
green. The dog collar device is now
ready to be linked, or paired, with a
handheld device.
3
On the handheld device, select Dog
List > Add Dog.
4
Bring the dog collar device near the
handheld device, and select Yes.
5
After successfully adding the dog
collar device, enter the name of the
dog, and select
shows the GPS signal strength.
100
®
until the dog collar device
> OK.
3