Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Instruction CF-RF Room Thermostat with Infrared Floor Sensor
Activate Install mode on Master Controller
- fig. 1.
• Use the menu selection button
Install mode. Install LED
• Activate Install mode by pressing OK
LED
goes ON
Activate Install mode on Room Thermostat
• Press the push button
during communication
Select output on Master Controller
• All available output LEDs on Master Controller
light up, and the first of them flashes
• Press output selection button
desired output (flashes) and accept with OK
• All output LEDs
stays ON shortly
Room Thermostat installation status
• Satisfactory - LED
• Not satisfactory - LED
Note: A Room Thermostat can be assigned to several
outputs if needed by repeating the installation process.
VI.UH.R2.1C
flashes
.
LED
, to select
go OFF. Selected output
goes OFF
flashes 5 times
Produced by Danfoss Floor Heating Hydronics 03.2007
to select the
.
Install
and
flicker
GB
5
Publicité
