Publicité
Les langues disponibles
Les langues disponibles
WARNING
!
•
Dynamic Heat Control™ MUST be installed during the installation of the appliance BEFORE appliance venting and gas
are installed.
•
Ensure the appliance is completely cool before starting installation.
•
To avoid danger of suffocation keep the packaging bag away from babies and children. Do not use in cribs, bed, carriages,
or play pens. This bag is not a toy. Knot before throwing away.
You will need:
PATENT PENDING
Installer:
•
Ability to use combustible framing and finishing right up to the fireplace opening.
•
High temperatures above the front of the fireplace opening are significantly reduced eliminating potential degrading
to sensitive finish material (cracks or discoloration).
•
No additional electrical, fans, ducts, or manifolds are required which keeps installation straightforward.
User:
•
Heat is circulated more consistently throughout the living space increasing comfort in front of the fireplace.
•
Increased "real world" efficiency as heat is moved in to the room rather than retained inside an enclosure.
•
Complete flexibility in selection of finish materials.
•
Ability to place a TV, sound bar or artwork above the fireplace.
The Dynamic Heat Control™ system relies on an optimized flow of air both through the appliance and the enclo-
sure. As such the installation of the Dynamic Heat Control™ system requires certain technical considerations when
compared to traditional fireplaces. Specifically, the Dynamic Heat Control™ requires the enclosure to be ventilated
and requires the installer to ensure that a minimum opening area is provided to allow heat to escape and circulate at
a prescribed minimum height and position. This must be carefully adhered to in the planning and the installation to
ensure the appliance functions safely and to minimize installation time.
*
In most common installation configurations, some specific installations require special provisions.
See "Framing with Dynamic Heat Control" section for details. Ensure to strictly adhere to instructions.
**
Always check appliance manufacturers recommendations to confirm suitability and any special
environmental limitations. For valuable or antique items, always refer to expert preservation instructions as
some items require specifically controlled temperature and/or humidity
All manuals and user guides at all-guides.com
Included in this kit
Bracket
Dynamic Heat Control™ is a system for managing the
heat produced by the appliance at and around the fireplace.
The purpose of the Dynamic Heat Control™ is to move
the heat away from the fireplace to allow it to circulate more
effectively within the living space. By installing the Dynamic
Heat Control™ both the installer and the user gain consid-
erable benefits, see the following;
1.0 general information
general information
a
Screws
b
Wire Harness
*
**
EN
Deflectors
High Limit Switch
3
W415-1739 / C / 08.03.17
Publicité
