Lux Tools B-FS-51/43 Notice Originale page 42

All manuals and user guides at all-guides.com
Motorsense_302135_115326.book Seite 42 Mittwoch, 11. Januar 2017 10:23 10
GB
• Remove all adjustment tools (mounting span-
ners etc) before switching the machine on.
• Never use saw blades as trimming tools.
• Do not operate the machine without the protec-
tive equipment being fitted.
• Protect the machine against hard blows! Do not
drop the machine! If the machine was exposed
to hard blows, make sure immediately that no
fuel is leaking (risk of fire and explosion!)
• Check the fuel system regularly for leaks or
defective parts.
• Make sure that no persons or animals are within
your work area when you start working.
• Before using the machine on surfaces to be
trimmed, search them for animals and objects.
Remove all objects, which could be flung by the
machine. Remove all long objects which might
become entangled with the trimming tool.
• Make sure there are no obstacles in your work
area.
• Ensure that your machine has been fully and
properly assembled.
• Check that the machine works properly and
make sure, in particular, that its rotating parts sit
tightly and properly.
• The machine will vibrate during operation. This
may cause its screws and parts to loosen.
Therefore, check all screws and parts for tight-
ness.
• Remember that moving parts may also be
located behind ventilation and venting slots.
• Symbols located on your machine may not be
removed or covered. Replace any information on
your machine immediately that it becomes illeg-
ible.
Read the instructions for use prior to oper-
ating the machine
Danger due to foreign bodies being thrown
out.
Do not use mowing discs or saw blades as
trimming tools!
Hazard due to hot surfaces!
Petrol is highly flammable. Before topping
up fuel, allow the motor to cool down for at
least 5 minutes.
Maintain a safety distance of 15 m
15m (50ft)
from people or animals in the vi-
cinity.
Personal protective clothing
Wear hearing and eye protection and a
safety helmetWear hearing and eye protec-
tion and a safety helmet
Wear protective gloves
42
Wear safety shoes
Your machine at a glance
Gasoline brushcutter
► P. 3, item 1
1. Operating handle
2. Shoulder strap lug
3. Motor
4. Operating bar
5. Top shaft tube
6. Bottom shaft tube
7. Protective hood
8. Trimming head
9. Connection piece
Operating handle
► P. 3, item 2
10. Throttle
11. Ignition switch
12. Throttle stop
13. Fuel lever lock
Motor
► P. 3, item 3
14. Ignition cable with spark plug
15. Choke lever
16. Pull starter
17. Filler opening for fuel mix
18. Fuel pump
19. Air filter casing
What is included
• Instructions for use
• Top shaft tube with motor
• Bottom shaft tube with trimming head
• Impact knife (with transport guard)
• Filament spool
• Protective hood
• Operating bar
• Shoulder strap
• Bag with small parts
Note: should any part be missing or dam-
aged, please contact your dealer.
Installation
DANGER! Risk of injury during opera-
tion! Any inappropriately installed parts
may cause serious or deadly injuries when
using the machine. This machine must not
be operated unless all parts have been fully
and tightly installed and no part is dam-
aged!
– Therefore read this chapter completely
before installing any parts!
– Make sure to install the parts com-
pletely and carefully.
– Use tools if specified.