Kenmore 587 1539 Serie Guide De L'utilisation page 7

Operating Instructions
Sani Rinse Option
To sanitize your dishes and glassware, select the SANI
RINSE option. When selected, the light above the pad will
come on and remain on until end of cycle. The water
temperature in the final rinse will be raised to 155°F
(68°C) assuring bacteria is destroyed. This option is
available in NORMAL WASH and UPPER RACK. SANI
RINSE is automatically provided when HEAVY WASH is
selected. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper water
temperature is reached. Washing action will continue
during the water heating delay. For best results, the
incoming water temperature should be at least 120°F
(49°C).
The sanitize criteria may not be satisfied if there is an
interruption of the cycle, power failure or if the incoming
water temperature is below 120°F (49°C).
To turn off the SANI RINSE option, press the pad a second
time. The light above the pad will turn off.
Status Indicator Lights
PF..................
1H-24H...........
Note: The time remaining could suddenly increase or drop several minutes. This means the iSense Soil Note: Note: Note: Note:
Sensor has checked the soil level and determined if additional water fills are needed or if water fills can
be deleted.
All manuals and user guides at all-guides.com
Appears in window when
dishwasher is first installed, or
when power has been interrupted.
HI-TEMP WASH and NO HEAT
DRY indicator lights will also flash.
To clear, touch START/CANCEL
pad.
Number of delay start hours. The
last hour will count down in
minutes.
The WASHING light comes on at the beginning of cycle
and remains on until the end of the main wash.
The DRYING light indicates the drying portion of the cycle.
The light will come on when either drying option is se-
lected.
When the SANI RINSE option is selected, the SANITIZED
light will glow when the SANI RINSE cycle is finished and
remain on until the door is opened. If the dishwasher did
not properly sanitize the dishes, the light will not come on.
This can happen if the cycle is interrupted or if incoming
water temperture is below 120
The CLEAN light will come on at end of cycle and remain
on until door is opened.
The RINSING AGENT LOW light, Located near the
Rinse Only Pad, comes on at the end of a cleaning cycle
when the rinse agent reservoir is low. The light will remain
on through 5 successive cycles or until the reservoir is filled.
In the unlikely event the dishwasher malfunctions, the
indicator may display one of the following codes "Er",
"uF", "uo", or "CE". If one of these codes are displayed
contact the Kenmore Customer Care Center at
4M 4MY Y Y Y Y -HOME. 4M 4M 4M -HOME. -HOME. -HOME. -HOME.
They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.
CL..................
Close dishwasher door. The status
indicator lights will also flash to
indicate current cycle status.
HO.................
Flashes to indicate a water heat
delay.
MINUTES.........
Number of minutes left in cycle (1-99).
If cycle is longer than 99 minutes, a
small plus sign will appear beside the
number of minutes and remain on
until time counts below 99.
7
F.
o
1-800- 1-800- 1-800-
1-800- 1-800-