Publicité
Les langues disponibles
Les langues disponibles
Care & Cleaning
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in burns.
Outside—
Occasionally wipe with a mild nonabrasive
detergent and water. Rinse and dry.
Models with Easy Care Real Stainless Finish
outer door with warm soapy water and a dishcloth or
sponge. Rinse with clean water and a dry cloth. Do not
use harsh cleaners.
Inside—
The inside of the dishwasher is self-cleaning with
normal use. If needed, clean around the tub gasket area
with a damp cloth.
The filter is self-cleaning. A glass trap located in the
center of the filter is designed to collect pieces of broken
glass, straws, bones and pits. To remove items in glass
trap, grasp handle, lift out, empty and replace.
Note: : : : : Hard water may cause lime deposit buildup on the
interior of the dishwasher. For cleaning instructions see
"Removing Spots and Film" section.
Overfill Protector—
keeps dishwasher from overfilling
and is located in the left front corner of the
tub.
• Clean occasionally with
household cleaner containing
vinegar or bleach to dissolve
any buildup.
• Overfill Protector should
move up and down freely
about one inch. If it does not
move, lift and clean underneath.
All manuals and user guides at all-guides.com
Burn Hazard
- Clean
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is usually
mounted on countertop and can be inspected by
removing the cover. This is not part of your dishwasher
and is not covered by warranty.
Property Damage Hazard
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to and circulating
lines within dishwasher are protected.
Failure to do so could result in property damage.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person do
the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the
supply source by removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water into
pan.
Note:
Note:
Note:
Note: See Installation Instructions for more details.
Note:
To Restore Service:
1. Reconnect the water, drain and electrical power
supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher through a
HEAVY WASH cycle.
4. Check connections to make sure they do not leak.
Note:
Note:
Note: See Installation Instructions for more details.
Note:
Note:
14
Publicité
