DeWalt XR DCD932 Traduction De La Notice D'instructions Originale page 217

All manuals and user guides at all-guides.com
ROTARY DRILLING (FIG. 1)
1. Set the mode selector switch (c) to the "rotary
drilling" position.
2. Depending on your tool, follow either of the
following instructions:
– Fit a chuck adaptor/chuck assembly
(DCH143, DCH243, DCH253). Special SDS
®
Plus adaptors with threaded sections are
available for use with standard 10 or 13 mm
chucks to enable straight shank bits to be
used.
®
– Replace the SDS Plus tool holder with the
keyless chuck (DCH254).
3. Proceed as described for rotary hammering.
WARNING: Never use standard chucks
in the rotary hammering mode.
SCREWDRIVING (FIG. 1)
1. Set the mode selector switch (c) to the "rotary
drilling" position.
2. Select the direction of rotation.
3. Depending on your tool, follow either of the
following instructions:
– Insert the special SDS Plus
adaptor for use with hexagonal screwdriver
bits (DCH143, DCH243, DCH253).
– Replace the SDS Plus ® tool holder with the
keyless chuck (DCH254).
4. Insert the appropriate screwdriver bit. When
driving slotted head screws always use bits with
a finder sleeve.
5. Gently press the variable speed switch (a) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
6. When the screw is flush with the workpiece,
release the variable speed switch to prevent
the screw head from penetrating into the
workpiece.
CHIPPING (FIG. 1)
1. Set the mode selector switch (c) to the
"hammering only" position.
2. Insert the appropriate chisel and check if it is
properly locked.
3 Adjust the side handle (e) as required.
4. Switch on the tool and start working.
It may be necessary to briefly run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
This machine is not user-serviceable. Take the
tool to an authorised D
approximately 40 hours of use. If problems occur
before this time contact an authorised D
repair agent.
The charger and battery pack are not serviceable.
® screwdriving
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
ENGLISH
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
WALT repair agent after
E
WALT
E
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
15