Bosch GTS1031 Consignes De Fonctionnement/Sécurité page 8

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 8
lEAdINg ENd
The end of the workpiece which, during a rip type
operation, is pushed into the cutting tool first.
MOldINg
A non-through cut which produces a special shape
in the workpiece used for joining or decoration.
NON THRU-SAWINg
Any cutting operation where the blade does not ex-
tend through the workpiece (e.g. Dado, Rabbet).
pUSH STICK
A device used to feed the workpiece through the
saw during narrow ripping-type operation and helps
keep the operator's hands well away from the blade.
Use the Push Stick for rip widths less than 6 inches
and more than 2 inches.
HEX "L" WRENCH
(Supplied-Insert Plate)
COMBINATION SQUARE
WARNING
Great user manuals database on
Tools Needed for Assembly And Adjustment
PHILLIPS SCREWDRIVER
2 MM
Disconnect plug from power source before performing any assembly, adjustment or repair
to avoid possible injury.
UserManuals.info
pUSH blOCK
A device used for ripping-type operations too narrow
to allow use of a Push Stick. Use a Push Block for
rip widths less than 2 inches.
RAbbET
A notch in the edge of a workpiece. Also called an
edge dado.
RIppINg
A cutting operation along the length of the workpiece
cutting the workpiece to width.
REVOlUTIONS pER MINUTE (R.p.M.)
The number of turns completed by a spinning object
in one minute.
COMBINATION SQUARE MUST BE TRUE
DRAW LIGHT LINE ON
BOARD ALONG THIS EDGE.
HEX "L" WRENCH
(Supplied-Tool Adjustment)
5 MM
-8-
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE
MUST BE PERFECTLY
STRAIGHT.
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.