Bosch GTS1031 Consignes De Fonctionnement/Sécurité page 35

BM 2610014415 01-11 E:BM 2610012089 12-10 E 1/10/11 7:17 AM Page 35
FIG. 59
The gear case has been completely lubricated at the
factory. However, after six months to one year, de-
pending upon use, it's wise to return your tool to the
nearest Service Center for the following:
• Brushes replaced.
• Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with
SAE No. 20 or No. 30 oil, or WD 40 (Fig. 60).
1. Elevation, support rods, and gears.
2. Sliding rails and supports.
3. Table locking cams (Front & Rear).
Item
Dust bag
Zero Clearance Insert
Dado Insert Set
Great user manuals database on
lUbRICATION
Recommended Accessories
Use only recommended accessories. Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
UserManuals.info
trained repairmen. Contact the nearest Factory
Service Center or Authorized Service Station or
other competent repair service. Use only identical
replacement parts, any other may create a hazard.
FIG. 60
2
Cat. No. Item
TS1004 Pusher Guide System
TS1012 Table Saw Stand
TS1013
-35-
All repairs, electrical or mechani-
cal, should be attempted only by
3
1
Cat. No.
TS1010
GTA500