Kenwood KNA-DV2100 Mode D'emploi page 51

Specifications
Specifications subject to change without notice.
Navigation Section
Antenna ............................................................................................................Micro-strip patched antenna
Receiver channel .................................................................................................. Digital 8-channels parallel
Receiving frequency ..............................................................................................1575.42 MHz (C/A code )
Receiving sensitivity ......................................................................................................Less than -130dBm
Positioning method ..................................................................Hybrid (GPS + Wheel Pulse + Gyro Sensor)
General
Operating voltage ......................................................................................................14.4 V DC (11 to 16 V)
Consumed current................................................................................................................Less than 2.5 A
Operational temperature range ............................................................................................–10°C to +55°C
Storage temperature range ..................................................................................................–30°C to +85°C
Video output level ( 75 Ω ) ........................................................1 Vp-p (Composite)/ 0.7 Vp-p (Analog RGB)
Audio output level ( 10 kΩ ) ............................................................................................................1.2 Vrms
Size
(Navigation unit) ..........................................................................................200(W) x 47(H) x 203.5(D) mm
(Antenna unit) ..................................................................................................34(W) x 13.2(H) x 38(D) mm
Mass
(Navigation unit) ..............................................................................................................1800 g (3.97 LBS)
(Antenna unit) ....................................................................................................................25 g (0.055 LBS)
Active speaker
Operating voltage ..............................................................................................................................5 V DC
Maximum output power ..................................................................................................................200 mW
Current consumption ........................................................................................................................150 mA
Speaker ................................................................................................................................................Ø 45
Size ....................................................................................................................73 (Diameter) x 23 (H) mm
2Warning
2CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
In compliance with Federal Regulations, following
are reproductions of labels on, or inside the
product relating to laser product safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS N0.21 CFR
1040. 10, CHAPTER 1, SUBCHAPTER J.
Location : Bottom Panel
FCC WARNING
This equipment may generate or use radio
frequency energy. Changes or modifications to
this equipment may cause harmful interference
unless the modifications are expressly approved in
the instruction manual. The user could lose the
authority to operate this equipment if an
unauthorized change or modification is made.
7-7/8(W) x 1-7/8(H) x 8-1/16(D) in.
1-5/16(W) x 1/2(H) x 1-1/2(D) in.
2-7/8 (Diameter) x 7/8(H) in.
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment may cause harmful
interference to radio communications, if it is not
installed and used in accordance with the
instructions. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE
This Class B digital apparatus complies with
Canadian ICES-003.
49