Kärcher BR 47/35 ESC Manuel D'utilisation page 21

The machine is started.
Note:
The device switches off when the waste
water tank is full. To restart the device,
empty the waste water tank and briefly set
the power switch to "0".
 Continue cleaning until the travellator/
escalator has completed 1 or 2 rounds.
Then move the machine towards the
side and start a new cleaning process.
Moving the appliance to the side
 Set the appliance switch to 'dry vacuum
cleaning' position. Dry vacuum cleaning
is activated.
 Let the pump pressure fall to 0 bar.
 Set the appliance switch to "0".
 Release the foot pedal.
 Press pedal for raising the brush head.
Brush head is raised.
 Move the appliance to the side.
 Press pedal for lowering the brush
head. The brush head will be lowered
and the lock lever will arrest in its posi-
tion.
 Press the foot pedal and place the ma-
chine centrally in the ridges of the
steps.
 Set the appliance switch to regular or
basic cleaning.
 Then clean using clear water so as to
remove detergent residues.
DANGER
Risk of injury! Upon refilling with cleaning
fluid, always move the device away from
the working position.
Shutting down
Complete cleaning
 Set the appliance switch to 'dry vacuum
cleaning' position. Dry vacuum cleaning
is activated.
 Let the pump pressure fall to 0 bar.
 Set the appliance switch to "0".
 Release the foot pedal.
 Activate the lever to lock and the pedal
to raise the brush head. Brush head is
raised.
 Release the rear wheels.
 Drive out the machine from the working
position and the podium until it is on firm
ground.
Turn off device
 Pull out the mains plug.
 Drain off and disose the remaining de-
tergent fluid.
 Drain out the dirt water and dispose it
off.
 Clean the inside and outside of the ma-
chine. Rinse the tanks with clear water.
 Store the machine in a frost-free room
on an even and clean floor.
 Lock the rear wheels.
 Remove the cordon from the travellator/
escalator only when the entire working
area is dry again. There is risk of acci-
dent on account of slipping even if the
travellator/ escalator is slightly moist.
Care and maintenance
DANGER
Risk of injury! Before performing any work
on the device:
 Set the appliance switch to "0".
 Pull out the mains plug.
 Lock the rear wheels.
 Drain off and disose the remaining de-
tergent fluid.
 Drain out the dirt water and dispose it
off.
EN – 7 21