Kärcher BR 47/35 ESC Manuel D'utilisation page 18

Symbols on the machine
Drain for waste water
Drain for fresh water
Fresh water reservoir filler neck
Parking brake
Foot pedal
1 2
Before Startup
 Remove all packaging material except
the wooden palette.
Installing the pushing handle
 Insert the pushing handle in the
grooves on the appliance.
 Fasten the pushing handle with the 4
screws enclosed in the packet.
 Fasten the covering flaps.
 Hang in the strain relief clamp at the
pushing handle.
18
Drain the fresh water
tank and waste water
tank prior to tipping the
device.
 Lock the rear wheels; remove the
wooden blocks used for stopping the
wheels.
 Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
 Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
 Slowly push the machine down from the
ramp.
Removing anti-frost agents
Note:
The device has been flushed with anti-
freeze during manufacturing. This anti-
freeze must be removed before initial start-
up.
 Fill in 10 litres of fresh water in the fresh
water reservoir.
 Press the foot pedal.
 Set the machine switch to basic clean-
ing.
 Keep the machine running until the
pressure on the manometer falls.
EN – 4
Unloading