Publicité
▪
Wire brushes (G): For cleaning stone, metal, aluminium, etc.
▪
Sleeves (R): Different sizes for mounting different accessory tools.
Cutter (Q): For cutting plastic, wood and soft metal.
▪
▪
Collet chuck key (A): For mounting accessory tools.
Tool Fitting
1. Always unplug the tool before installing or exchanging the tool bit!
2. To insert a tool bit e.g. a wire brush (G), press the locking button (3). Use
the provided collet chuck key (A) to turn the locknut of the tool holder
(1) counter clockwise to loosen.
3. Insert the selected tool into the chuck as far as it will go and firmly
tighten the locknut, while holding down the locking button (3).
3
Initial Operation
1. Ensure that the ON/OFF switch (4) is switched off.
2. Then plug in the tool.
3. Use the ON/OFF switch to switch on the tool. The unit starts up.
4. Use the rotation speed regulator (5) to setup the desired no-load
rotation speed. The proper speed depends on the tool used and the type
of material to be processed.
5. The correct way to hold the machine is to grasp the casing firmly with
thumb and index finger, just like holding a pen. Take care not to cover
the ventilation slots on the side cover of the machine. A whining start up
noise is normal and no reason to worry.
Locknut
R
15
G
A
Publicité
