Publicité
Notes:
▪
Exert only moderate pressure on the workpiece and allow it to be
processed at uniform speed. You will not finish your work sooner by
exerting heavy pressure. On the contrary, heavy pressure will cause the
drive unit to slow down or stop. This may overload the motor.
▪
For your own safety, use a vice or screw clamp to secure small
workpieces.
▪
If possible, hang the tool on a support stand if you are using the flexible
shaft. Do not kink or bend the flexible shaft very much while working.
Installing the flexible Shaft
1. Unscrew the end cap (2) from the front side of the tool.
2. Unscrew the collet chuck nut.
3. Insert the internal shaft of the flexible shaft (7) into the collet chuck.
4. Tighten the collet chuck nut.
5. Now screw the end cap of the flexible shaft onto the tool head.
6. Insert the desired tool bit into the tool
holder of the flexible shaft.
7. Insert the locking tool (D) into the
opening below the arrow marking on the
tool holder of the flexible shaft.
8. Use the provided collet chuck key (A) to
tighten the collet chuck nut of the flexible
shaft clockwise and fix the inserted tool
bit.
End cap of the
flexible shaft
16
Collet chuck
7
nut
D
A
Publicité
