Whirlpool MW B00 Mode D'emploi page 2

All manuals and user guides at all-guides.com
PRIOR TO CONNECTING
Check that the voltage on the rating plate
corresponds to the voltage in your home.
Do not remove the microwave inlet
protection plates located on the side of the
oven cavity wall. They prevent grease & food
particles from entering the microwave inlet
channels.
Ensure the oven cavity is empty before
mounting.
Ensure that the appliance is not damaged.
Check that the oven door closes fi rmly against
the door support and that the internal door
seal is not damaged. Empty the oven and clean
the interior with a soft, damp cloth.
Do not operate this appliance if it has
a damaged mains cord or plug, if it is not
working properly, or if it has been damaged
or dropped. Do not immerse the mains cord
or plug in water. Keep the cord away from hot
surfaces. Electrical shock, fi re or other hazards
may result.
This product should not be mounted at a
height lower than 850 mm above fl oor level.
Follow the supplied separate mounting instructions
2
INSTALLATION
AFTER CONNECTING
The oven can be operated only if the oven
door is fi rmly closed.
The earthing of this appliance is compulsory.
The manufacturer will accept no responsibility
for injury to persons, animals or damage to
objects arising from the non-observance of this
requirement.
In the case of a permanent connection, the
appliance should be installed by a qualifi ed
technician.
Important!
A permanent connection requires the
installation of a separating device. The
separating device must have an omnipolar
contact opening of more than 3 mm including
LS switches, safety valves and relays. The
separating device must be connected directly
to the terminal.
The manufacturers are not liable for any
problems caused by the user's failure to
observe these instructions.
when installing the appliance.