62 www.aeg.com
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
Alarm code
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 1 time in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 2 times in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 3 times in-
termittently.
WARNING!
Deactivate the appliance before
you do the checks.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
With some problems, different indica-
tors flash continuously or intermittent-
ly at the same time to show an alarm
code.
Problem
The appliance does not fill with water.
The appliance does not drain the wa-
ter.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.