Bertazzoni P784I1M30NV Manuel D'installation Et D'instructions page 41

Installation
Choosing installation equipment
Cut out the work surface according to the sizes shown in the drawing.
Leave a space of at least 5 cm around the hole for the purpose of installation and use.
Make sure the work surface is at least 30 mm thick. Please select a heat-resistant work surface
material to avoid extensive deformation due to the heat radiated by the hotplate. As shown
below:
L(mm) W(mm)
780 520
Under all circumstances, make sure the induction hob is well ventilated and that the air
inlet and outlet are not blocked. Ensure the induction hob is in good working condition as
shown below.
Note: Leave a safety distance of at least 700 mm between the hotplate and the
cupboard above the hotplate. If over the hob a hood is installed, keep as
reference the distance indicated into the hood user manual.
H(mm) D(mm)
60 56
A(mm) B(mm)
755 495
18
X(mm)
50 min.