Bertazzoni P905I2M30NV Manuel D'installation Et D'utilisation page 41

Failure Display and Inspection
If a fault occurs, the induction hob will enter the protection state automatically and display the
corresponding error codes:
Error Message
No pan or pan unsuitable;
ER03 Water or pan on the glass over the control
The connection between the display board and the left
F1E
mainboard has failed (in the cooking zone for which the
indicator is showing "E")
Coil temperature sensor failure. (in the cooking zone for
F3E
which the indicator is showing "E" )
Mainboard temperature sensor failure. (in the cooking
F4E
zone for which the indicator is showing "E" )
Temperature sensor of the ceramic glass plate is high
E1E
Temperature sensor of the IGBT is high
E2 E
Abnormal supply voltage (too high)
E3 E
Abnormal supply voltage (too low)
E4 E
Temperature sensor failure (in the cooking zone for
E5 E
which the indicator is showing "E")
The above are causes and solutions of the most common failures.
Do not disassemble the unit by yourself to avoid any hazards and damage to the induction
please contact the supplier.
hob, and
Possible Cause
18
What to do
Replace the pan:
Clean the user interface
Connection cable not plugged in properly or
1.
defective;
Replace the mainboard.
Replace the coil sensor
Replace the mainboard
Please restart after the induction hob has cooled
down.
Please restart after the induction hob has cooled
down.
Please check that the power supply is normal;
Power on when the power supply is normal.
Please check that the power supply is normal;
Power on when the power supply is normal.
Connection cable not plugged in properly or
defective assembly;