Electrical Connections - Foster 7322/300 Manuel D'installation Et D'utilisation

installation

Electrical connections

Before making the electrical connections, check that:
• the system ratings meet the ratings indicated on the identification plate fixed on
the lower part of the worktop;
• the system is fitted with efficient ground wires in accordance with the laws and
current standards.
If the domestic appliance is not supplied with a cable and/or suitable plug, use
material suitable for the absorption value indicated on the identification plate and
the operating temperature.
If wishing to make a direct connection to the mains, an omnipolar switch must be
installed with a minimum 3 mm opening between the contacts and appropriate
for the load indicated on the plate and in accordance with current standards (the
yellow/green ground conductor must not be disconnected by a switch).
When the appliance has been installed, the omnipolar switch must be easily
reachable.
WARNING! THIS APPLIANCE MUST BE GROUNDED
The electrical safety of this appliance can only be guaranteed when continuity is
complete between it and an effective earthing system, which complies with current local
and national safety regulations. It is most important that this basic safety requirement
is present and regularly tested and, where there is any doubt, the electrical wiring in the
home should be inspected by a qualified electrician. The manufacturer cannot be held
liable for the consequences of an inadequate earthing system such as an electric shock.
The manufacturer cannot be held liable for damage which is the direct or indirect result
of incorrect installation or connection.
L
220-240V
N
~
H05V2V2-F 3G / 1,5 mm
L (brown)
N (blue or grey)
GND (green/yellow)
L1
2
220-240V2
L2
~
19