CGS Merlin GDP4 Manuel D'installation Et De Maintenance page 12

Installation & Operation Manual Merlin GDP4
Installation Details
Please pass this manual to the system owner / user.
Date of Installation:
Installation Location:
Organisation:
Stamp/Signature of the installer:
We recommend all Merlin gas detection equipment be commissioned by a competent/trained engineer to ensure
correct installation and operation. The Merlin range of gas detectors are calibrated when manufactured, however,
we strongly recommend the detectors response and alarm signals are tested and validated once installed. This will
ensure the equipment performs as intended and is free from any unforeseen damage caused by transit/installation.
Every effort is made to ensure the accuracy of this document; however, CGS can assume no responsibility for any
errors or omissions in this document or their consequences. CGS would greatly appreciate being informed of any
errors or omissions that may be found in the content of this document. For information not covered in this
document, or if there is a requirement to send comments/corrections, please contact CGS using the contact details
given below.
Canadian Gas Safety
info@canadiangassafety.com
Telephone: 647-577-1500
CGS is the owner of this document and reserves all rights of modification without prior notice.
Rev: 01
12