Conversion - DJO Ormed Artromot-SP3 Mode D'emploi

6.4 Conversion

The ARTROMOT®-SP3 can be used for the
left and for the right ankle joint. However,
the device must be converted first. This is
done very quickly.
1. Activate the "transport setting" function
in the menu (also refer to 5.3)
and start the ARTROMOT®-SP3.
2. Remove the footplate (7) as well as its
bracket (11). To do so, pull it from the
square-end guide at motor B. (Fig. G)
3. Loosen thumbscrew (12) used to mount
motor B to the moving bracket (15).
Then pull the motor upward and remove
(Fig. H).
4. Mount motor B on the opposite side of
the carriage, using the thumbscrew.
5. Push the footplate bracket including the
footplate into the square-end aperture
on motor B. Observe the marks: red dot
on square rod of the footplate bracket to
match red dot on square-end aperture
on motor B, mark L or R on the footplate
bracket to match mark L or R on the
motor housing.
Note!
– To assist in the conversion, motor B
is equipped with a side identification
function.
The following symbols may appear
on the display during conversion:
(example)
conversion from left to right:
Motor on the left-hand side:
Motor removed from bracket:
Conversion to the right-hand side
completed:
– If, after the conversion, the footplate
bracket, i.e., the footplate is at an
inadmissible angle, the display shows:
Please press the START button and
the carriage will automatically move
to the permitted range and stop.
68