Description Of The Device Components - DJO Ormed Artromot-SP3 Mode D'emploi

2.1 Description of the device
components
Note: Please fold out page ΙΙΙ!
1. Clamping levers to adjust the height
of the calf support assembly
2. Calf support assembly
3. Motor A (center of rotation for dorsal
extension/plantar flexion)
4. Bracket for control pendant
5. Clamping lever to adjust the inclination
of the carriage
6. Aiming pin for adjustment of the
rotational axis of the upper ankle joint
7. Footplate
8. Knurled screw for adjustment of the
footplate height
9. Knurled screw to adjust the footplate
to the leg length
10. Motor B
11. Footplate bracket
12. Thumbscrew to secure motor B on the
moving bracket for dorsal extension /
plantar flexion
13. Bore hole to mount motor B to the
moving bracket for dorsal extension /
plantar flexion
14. CPM base
15. Moving bracket for dorsal extension /
plantar flexion
16. Power switch (ON/OFF)
17. Fuse cap
18. Connection for power cord
19. Locking device to adjust the height of
the carriage
20. Perforation to set the height of the
carriage
21. Patient chip card¹
22. Control pendant
23. Rating plate
24. Connection for control pendant
41