Publicité
Les langues disponibles
Les langues disponibles
STEP-BY-STEP INSTALLATION GUIDE
3
Turn two full turns on each screw
The Filler Block is only used for recessed cabinet and
front overhang cabinet (see the type of the cabinet on
pages 8–10). Place the Filler Block to the cabinet bottom
before installing the oven.
5. Tighten the outer two screws to the top of the microwave
oven. While tightening screws, hold the microwave oven
in place against the wall and the top cabinet.
Cabinet front
Cabinet bottom
Microwave oven top
6. Install grease filters. See the Use & Care Manual packed
with the microwave.
Over The Range Microwave Oven / Installation Manual
Cabinet mounting bolt
Washer
Washer
Filler block
Equivalent to
depth of cabinet
recess
Cabinet mounting bolt
C5.
CHANGE THE CHARCOAL FILTER
The charcoal filter is used for nonvented, recirculated instal-
lation. The filter should be changed every 6 to 12 months
depending on use.
1. Remove two screws of the louver on the top of the oven
by using a #1 Phillips screwdriver.
Louver
Charcoal Filter
2. Open the door, remove the louver and take the used
charcoal filter out.
3. Install the new charcoal filter. When properly installed,
the wire mesh of the filter should be visible from the front.
4. Replace the louver and the screws.
Louver Screws
Charcoal
Filter
21 / 24 EN
Publicité
