Beko MWOTR24100SS Manuel D'installation page 18

STEP-BY-STEP INSTALLATION GUIDE
3
B5.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during installation.
If filler blocks are not used, outer case damage may occur
from over tightening screws.
Note: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
We recommend using filler blocks if the cabinet front hangs
below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord
through hole in bottom of top cabinet. Keep it tight throughout
steps 1–4. Do not pinch cord or lift oven by pulling cord.
1. Lift microwave, tilt it forward and hook slots at back bottom
edge onto four lower tabs of mounting plate.
2. Rotate front of oven up against cabinet bottom.
3. Attach the microwave oven to the top cabinet.
4. Insert two cabinet mounting bolts through outer top cabinet
holes. Temporarily secure the oven by turning the screw
at least two full turns after the threads have engaged (it
will be completely tightened later). Be sure to keep power
cord tight. Be careful not to pinch the cord, especially when
mounting flush to the bottom of cabinet.
Nylon grommet
Metal cabinet
18 / 24 EN
Power cord
Power cord
hole
Over The Range Microwave Oven / Installation Manual
Turn two full turns on each screw
The Filler Block is only used for recessed cabinet and
front overhang cabinet (see the type of the cabinet on
pages 8–10). Place the Filler Block to the cabinet bottom
before installing the oven.
5. Tighten the outer two screws to the top of the microwave
oven. While tightening screws, hold the microwave oven
in place against the wall and the top cabinet.
Cabinet front
Cabinet bottom
Microwave oven top
6. Install grease filters. See the Use & Care Manual packed
with the microwave.
Cabinet mounting bolt
Washer
Washer
Filler block
Equivalent to
depth of cabinet
recess
Cabinet mounting bolt