Beko MWOTR24100SS Manuel D'installation page 19

STEP-BY-STEP INSTALLATION GUIDE
3
C. RECIRCULATING (NON-VENTED DUCTLESS)
Installation overview
C1. Attach the mounting plate to the wall
C2. Use Top Cabinet Template for preparation of top cabinet
C3. Adapt blower for recirculation
C4. Mount the microwave oven
C5. Change the charcoal filter
C1.
ATTACH MOUNTING PLATE TO THE WALL
Attach the mounting plate to the wall using the wing nuts and
toggle bolts. At least one lag screw must be used to attach
the mounting plate to a wall stud.
1. Insert the toggle bolts into the mounting plate through the
holes designed to go into drywall and attach the wing nuts
to 3 ⁄ " (1.9 cm) onto each toggle bolt.
4
2. Place the mounting plate against the wall and insert the
wing nuts into the holes in the wall to mount the plate.
CAUTION CAUTION Be careful to avoid pinching fingers between
the back of the mounting plate and the wall.
Over The Range Microwave Oven / Installation Manual
3. Tighten all bolts. Pull the mounting plate away from the
wall to help tighten the bolts.
Spacing for toggles more
than wall thickness
Wing nut
Toggle
Bolt
5 / "
8
Wall
C2.
USE TOP CABINET TEMPLATE FOR PREPARATION
OF TOP CABINET
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
• Read the instructions on the Top Cabinet Template.
• Tape the template underneath the top cabinet bottom.
• Drill the holes, following the instructions on the Top
Cabinet Template.
CAUTION CAUTION Wear safety goggles when drilling holes in the
cabinet bottom.
Bolt end
19 / 24 EN