Beko MWOTR24100SS Manuel D'installation page 17

STEP-BY-STEP INSTALLATION GUIDE
3
B4.
ADAPT MICROWAVE BLOWER FOR OUTSIDE REAR
EXHAUST
1. Remove and save screw that holds blower motor to
microwave. Lift up the blower plate.
Blower motor
2. Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan blade
openings facing UP
3. Remove Part A with tin snips.
4. Rotate blower unit counterclockwise 90°.
Before rotation
Back of microwave
Over The Range Microwave Oven / Installation Manual
Back of
microwave
Blower plate screw
Blower motor screw
Part A
After rotation
Back of microwave
5. Place the blower unit back into the opening.
AFTER: Fan blade
openings facing BACK
End B
CAUTION CAUTION
Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
Note: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
6. Replace the blower plate in the same position.
7. Attach the exhaust adapter to the rear of the oven by
sliding it into the guides at the top center of the back of
the oven.
Push in securely until it is in the lower blower motor screw.
Take care to assure that the damper hinge is installed
so that it is at the top and that the damper swings freely.
Adapter
Guide
8. Secure the blower motor unit to the microwave with screws
as before.
Adapter Blower motor screws
9. Secure the blower plate to the microwave with screws.
Replace the blower plate in the same position.
Adapter
Blower plate screw
End A
Back of
microwave
Guide
Blower motor screws
Blower plate
Back of
microwave
Blower Plate
Back of
microwave
Blower plate &
adapter screw
17 / 24 EN