Publicité
Les langues disponibles
Les langues disponibles
STEP-BY-STEP INSTALLATION GUIDE
3
C. RECIRCULATING (NON-VENTED DUCTLESS)
See page 18.
A. OUTSIDE TOP EXHAUST (VERTICAL DUCT) DEFAULT
Installation overview
A1. Attach the mounting plate to the wall
A2. Use Top Cabinet Template for preparation of top cabinet
A3. Check for proper damper operation
A4. Mount the microwave oven
A5. Adjust the exhaust adapter
A6. Connect ductwork
Over The Range Microwave Oven / Installation Manual
A1.
ATTACH MOUNTING PLATE TO THE WALL
Attach the mounting plate to the wall using the wing nuts and
toggle bolts. At least one lag screw must be used to attach
the mounting plate to a wall stud.
1. Insert the toggle bolts into the mounting plate through the
holes designed to go into drywall and attach the wing nuts
to
3
⁄
" (1.9 cm) onto each toggle bolt.
4
2. Place the mounting plate against the wall and insert the
wing nuts into the holes in the wall to mount the plate.
CAUTION
Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
3. Tighten all bolts. Pull the mounting plate away from the
wall to help tighten the bolts.
Spacing for toggles more
than wall thickness
Wing nut
Toggle
Bolt
5
/
"
8
Wall
Bolt end
13 / 24 EN
Publicité
