UNITED OFFICE ULG 350 B1 Mode D'emploi page 23

Disposal of the packaging
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material and
reduces the amount of waste generated. Dispose of packaging material that is
no longer needed as per the regionally established regulations.
NOTICE
► If possible preserve the appliance's original packaging during the warranty
period so that, in the event of a warranty claim, you can package the appli-
ance ideally for its return.
Requirements on the installation site
For safe and flawless operation of the appliance, the installation site must comply
with the following requirements:
■ When setting it up, place the appliance on a firm, flat and horizontal surface.
■ Set up the appliance so that there is at least 30 cm of free space in front of
the laminator. Otherwise, the pouch will not be ejected completely from the
laminator after lamination.
■ Do not operate the appliance in a hot, wet or very humid environment or
close to combustible material.
■ The mains power socket must be easily accessible, so that the power cable
can be easily disconnected in the event of an emergency.
Electrical connection
IMPORTANT
► Before you connect the appliance, compare the connection data (voltage
and frequency) on the data plate with that of your mains power network.
This data must match in order to avoid any damage to the appliance.
► Ensure that the power cable is undamaged and is not routed over hot
surfaces and/or sharp edges.
► Ensure that the power cable is not taut or kinked.
► Do not let the power cable hang over edges (trip wire effect).
♦ Insert the plug into a mains power socket.
GB │ IE
│
■ 20
ULG 350 B1