Henco UFH-THERM-WD Guide Utilisateur page 9

INSTALLATION PARAMETERS MENU
Press the (OK) key during 5 seconds, then use (-◄)
or (►+) to select the installation parameter to be
adjusted.
Press (OK) to toggle the parameter setting or edit
the value.
If the value starts to blink you can use (-◄) or (►+)
keys to adjust this value.
Press (-◄) or (►+) keys at the same to reset this
value to the factory default value. Once you have
adjusted the value press (OK) to validate this
parameter value. When you have finished, use (-◄)
or (►+) keys to go to "End" display and then press
(OK) key to exit installation parameter menu.
9