Henco UFH-THERM-WD Guide Utilisateur page 13

The calibration must be done same as described
above if the external sensor is connected and
used like an external ambiance sensor.
If the external sensor is used as floor sensor, the
thermometer should be put on the floor.
FL: Lower limitation of the floor temperature. Only
effective if the external sensor is connected and
selected:
Adjustable From 5°C to „FH"
5°C
FH: Upper limitation of the floor temperature. Only
effective if the external sensor is connected and
selected:
28°C
J7: Selection of regulation type:
rEg: Proportional band (PWM)
hys: Static differential of 0.3°K
CY: Proportional Integral regulation time cycle:
Adjustable From „Fl" to 37°C
13