R&G FI0115BK Instructions De Montage page 2

Please note that in cases where kits are packed with rubber washers holding the components onto the bolt –
Right-hand side (as you sit on bike)

Fit the counter sunk headed bolt through frame insert so head sits in counter-sink.

Place special nut on exposed end of bolt so tapered face goes into tapered recess.

Tighten bolt until tapered portion of nut just contacts tapered face of plastic frame insert.

Place the assembly into spindle in the position shown above with recess horizontal as shown
above.

Tighten bolt so frame insert is held in position firmly (do not over tighten).

Place bubble sticker as shown above.

Regularly check to ensure frame insert remains tight.
the rubber washers should be thrown away!
TOOLS REQUIRED

3mm metric Allen key.