SPORTSTECH SKY F2 Manuel page 62

CHECKING FIXING MATERIAL AND COMPONENTS
• Before each training session, check the tightness of bolts and nuts; especially at
handlebars, pedals and other moveable parts. Re-tighten, if necessary. Never start or
continue a training when components are loose or even damaged.
• At least once per month, check the firm seat of the LED adapters. For this, remove the
front and the rear cover of the main frame (see step 2 of the assembly instructions) and
check that the LED adapters are firmly clamped on the wheel circumference.
CLEANING
• Before each training session, with a softly wetted cloth, remove dirt and dust from the
rails below the pedals and from the pedal rollers.
• After each training session, with a softly wetted microfiber cloth, remove sweat from
your training device. Do not use solvents. DO NOT use any liquids near power supply,
computer or other electric or electronic devices.
CARE, CLEANING & MAINTENANCE
LUBRICATION
• Every few weeks, apply a very small amount of
suitable lubrication spray:
• The spray should be suitable for metal and
it should contain a sufficient amount of
lubricant. WD40, for example, serves mainly
for cleaning.
• Apply the spray at all joint bearings, slide
bearings and rollers; and, if necessary against
noise, a very small amount also at the rails.
Cleaning
Lubrication
Firmness checking
LED adapters checking
62