SPORTSTECH SKY F2 Manuel page 42

13
8
51
9
54
10
14
105
9
51 8
LED
Optionally, install the wheel illumination LED adapters
Removing the insulating paper from a new delivered LED adapter/
Exchanging the batteries
To prevent discharging of the batteries, newly delivered LED adapters are equipped
with an insulating paper. It has to be removed before first installation. The procedure
for battery exchange is similar. However, the insulating paper is already removed then.
112
115
113
51
8
9
14
18
55
59
• For battery exchange: Unclamp the adapter from the wheel,
2
2
• Carefully loosen the small screws (2) and remove the LED
110
• Unscrew the metal cover (111) from the LED housing.
112
• At new LED: Remove the insulating paper (115).
112
111 • At used LED: Remove the old batteries (112), if required.
• Make sure 3 sufficiently charged button cells LR1130
• Screw the metal cover at the LED housing. Insert the
114
• Repeat these steps for the other LED.
#8 M8x20xS5 (6 PCS)
#51 M8*20*S13 - 6 PCS
#9 d8 (6 PCS)
#10 d8xØ20x2xR30 (2 PCS)
#14 d8xØ20x2 (4 PCS)
#A S5 (1 PC)
#C S13 S15 - 1 PC
18
105
Step 2:
• Remove Bolts (51), Spring washers (9),
Washer (14) and Arc washers (10) from
Main housing (59) by Wrench (C).
• Connect Cable 1 (18) with Cable 2 (105).
• Fix Central post (13) to Main housing
(59) with Bolts (51), Spring washers (9),
Washer (14) and Arc washers (10) by
Wrench (C).
as shown on the next page.
housing from the LED clamping adapter (114).
(112) are properly inserted in the housing.
housing into the LED adapter. Fix it properly with the screws
(2).
42
LED/ADAPTER (2 St.)
#23 d8xØ20x2xR15 (4 St.)
#30 Ø30xØ20x10 (2 St.)
#71 ST4.2x16xØ8 (2 St.)
#8 M8x20xS5 (2
#24 M8xH7.5xS
#31 M8x16xS
#A S5 (1