SPORTSTECH SKY F2 Manuel page 43

• Remove the Rear cover from the Main housing.
• Through the opening, clamp the first LED adapter safely on the wheel cirumference on the right side of the
wheel. Hold it with both hands to prevent it from falling into the housing. Make sure it cannot be flung off
when the wheel spins.
• Turn the wheel by 180 degrees, so that the installed LED adapter is in the lowest possible position .
• Install the second LED adapter on the other side of the wheel: Clamp it safely on the wheel circumference
on the left side of the wheel. Hold it with both hands to prevent it from falling into the housing. Make sure it
cannot be flung off when the wheel spins.
Make sure to clamp the LED adapters always firmly and safely at the wheel's rim. There is
the risk of personal injury and material damage when LED adapters are flung off the wheel.
The LEDs will switch on and off automatically by centrifugal force.
If a LED housing is beyond repair, make sure to remove all batteries before disposing of the
housing as electronic waste. Dispose of empty batteries as special separate waste (see also
'DISPOSAL' section of this manual).
Generally, finish Step 2 as follows:
• Fix Front cover (54) and Rear cover (55) to Main housing (59).
2
43
1
EN