Listening To The Radio - JVC UX-G50 Manuel D'instructions

Listening to the Radio

To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Remote control:
1
sec.
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen
The MONO indicator lights on the display.
FM MODE
Reception will improve though stereo
effect is lost—Monaural reception mode.
To restore the stereo effect, press the
button again (the MONO indicator goes
off).
FM AM
Main unit:
1
sec.
DOWN UP
Remote
ONLY
To preset the stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
2
Activate the preset number entry mode.
SET/RESUME
• Finish the following process while the indication on the
display is flashing.
3
Select a preset number for the station you store.
Examples:
1 2 3
To select preset number 5, press
5.
4 5 6
To select preset number 15, press
= >
7 8 9
To select preset number 30, press
= >
0
10
• You can also use the PRESET UP/PRESET DOWN
buttons.
4
Store the station.
SET/RESUME
memo
• If you preset a station set to MONO, the station is stored
with the MONO setting.
Remote
ONLY
10 → 1 → 5.
10 → 3 → 0.
10