Publicité
Les langues disponibles
Les langues disponibles
GB
General information
Notes
• The wireless chime is only designed for use with the appropriate batteries.
• To be able to use the Wireless motion detector, you will need a receiver
(bell) from the Orchestra range
• In combination with a receiver (gong), the motion detector offers you the
opportunity to set up a bell system without wiring.
• This set is not intended for integration into an existing bell system.
• The range between transmitter and receiver is maximum 100m in the open field
The radio signal is transmitted through walls, walls, furniture and other obstacles,
but depends on the structural conditions - walls, especially reinforced concrete
walls, heat-insulating glazing and ceilings lead to a reduction in range.
• Shielding caused by metal parts can severely impair reception, so that the signal
cannot be transmitted. For this reason, never attach the transmitter to metal
surfaces.
• If the product is not in use for a long period of time, remove the batteries.
• The product has no replaceable parts. Do not try to open or repair the product.
Technical Data
Range (free field):
Frequency:
Frequency band:
Max. transmission power:
Coverage angle:
Detection zone:
Time between 2 recordings:
Battery:
Degree of protection:
Degree of protection:
13
Please thoroughly read the following operating instructions before
placing the device into service and keep for future reference. The bell
button is suitable for operation in protected outdoor areas and not in
harsh environments. The wireless chime is intended for installation in
dry indoor areas (IP20).
max. 100m
433,92MHz
433,05 – 434,79MHz
<10mW
approx.110°
approx. 4m
5 seconds
1x 3V C R2450 (included in delivery)
IP20 (for dry indoor use only)
Safety Extra Low Voltage
Publicité
