REV Ritter SA-IR07-NWX03-D Manuel D'utilisation page 15

Creating/deleting coding
Prior to coding, you require a receiver (chime) of the series Orchestra, refer to
"Compatible Products".
Coding the chime and motion detector:
1. Before coding, select your preferable bell tone (refer to"Volume setting/
Melody selection").
2. Remove the battery from the motion detector.
3. Press the "Volume" button on the chime for 5 seconds. You will hear a
ding-dong and the LED starts blinking, to signalise that the coding mode is
active.
4. Place the battery in the motion detector and make a movement in the detection
zone of the motion detector. If coding was successful, the chime will automati
cally play back the selected bell tone.
Note:
• The coding mode is automatically terminated after concluding the coding.
• The coding mode is only active for 5 seconds.
• The coding mode is always only available for one receiver (chime) and transmitter
(bell push, motion detector, window contact) simultaneously. Repeat the above-
mentioned coding if you would like to code multiple receivers/transmitters.
• You can assign a different bell tone to each transmitter when coding and in doing so,
create a call differentiation.
• Up to 20 receivers (chime) can be assigned to one transmitter (bell push, motion
detector, window contact). Refer to "Compatible Products".
• Up to 20 transmitters (bell pushes, motion sensors, window contacts)
can be assigned to one receiver (chime). Refer to "Compatible Products".
15