Optika Italy B-60 Serie Mode D'emploi page 15

10. Use of the digital head
10.1 Operation procedure
10.1.1 Connect the power adapter to the camera
1. Insert the power adapter into the power socket
the back side of the camera. (Fig. 18)
• After the connection, the red light will light up.
2. Press the power button
3. The indicator light will change from red to green, and the
camera will start up.
• Warning: disconnect the power supply if the equipment
is not used for a long time.
10.1.2 Use of the rear buttons
1. Use the rear buttons to operate the camera functions and
adjust the camera parameters.
2. After modifying the parameters, a dialog box appears allow-
ing to save the modified parameters.
3. In the upper left corner of the screen, "Param. saved " ap-
pears. (Fig. 20)
10.1.3 Snap
③
• The snap button
the power button. (Fig. 19)
1. Press it to capture the current image on the screen and store
it in the SD card.
2. The screen shows "Snap Succeeded", which means that the
picture has been taken successfully. (Fig. 21)
②
. (Fig. 19)
is on the right side of the camera, above
①
placed on
Page 15
①
③
②
F ig. 18 F ig. 18
F ig. 19 F ig. 19
F ig. 20 F ig. 20
F ig. 21 F ig. 21