Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If the calibration was successful "KALIBR OK! SPEICH / CALI OK! SAVE" will
appear. If the calibration was unsuccessful "KALIBR. FEHLER / CALI FAILED" will
appear. In this case please repeat the calibration process.
"KALIBR. GEHEN / CALI FOR WALKING" will now appear on the display.
Complete the calibration for walking in the same way as the calibration for
running.
The calibration can be aborted by pressing MODE.
Exit setting mode by pressing MODE.
Odometer
(GESAMT-DIST/ODOMETER)
The bottom row of the display will show the total covered distance. The value can
be reset by pressing and holding SET.
Pedometer
(SCHRITTE/STEP)
The bottom row of the display will show the step count. The value can be reset by
pressing and holding SET.
Calories, fat burn and BMI
The lower row will show the burned calories in kcal (KALORIEN/CALORIE).
Press SET to switch to the display of fat burn in gram (FETT/FAT BURN) or to the
display of your BMI (Body Mass Index).
In the display for calorie burn or fat burn the values can be reset by pressing and
holding SET.
Note: To increase the accuracy of the calorie and fat burn displays your age and
weight must be set correctly.
Note: The counter for fat burn is only activated while your heart rate is above 120
beats per minute.
(KALORIEN/CALORIE)
- 91 -
Notes on the BMI
The BMI is a statistical measurement that can be used to judge a persons weight.
For adults, a value between 18.5 and 25 is considered normal. Values below
18.5 are considered "underweight". Values above 25 are considered
"overweight". Values above 30 are considered "Obese".
The BMI is only a coarse guideline because it does not take a persons body type
and body composition into consideration.
Heart rate
(PULS/HRM)
If the chest belt is worn the current heart rate will appear on the bottom row of the
display.
Timer
(TIMER)
The bottom row of the display will show the elapsed time. The value can be reset
by pressing and holding SET.
Distance
(DISTANZ/DISTANCE)
The bottom row of the display will show the covered distance. The value can be
reset by pressing and holding SET.
Average speed
(DURCH-GESCHW/AVG SPEED)
The bottom row of the display will show the average speed. The value can be
reset by pressing and holding SET.
Maximum speed
(MAX GESCHW/MAX SPEED)
The bottom row of the display will show the maximum speed. The value can be
reset by pressing and holding SET.
- 92 -
Publicité
Table des Matières
